program parameter

We concluded that for any production program or adjusting the wells location, the parameter study is very important.

研究结论是，参数研究在所有生产规划或调整井定位的过程都非常重要。

The program use 4 parameter to control steering linkage, code the 4 parameter respectively, and adopt the model of keeping classic species.

程序使用4个参量控制梯形，对4个参量分别编码，采用精英保留模型，经三代遗传操作后得到了优化结果。

Due to the trapezoid thread's complicated machining, parameter programming can be used to compile its machining program to a subprogram.

针对梯形螺纹加工较繁琐的特点，利用参数编程，将梯形螺纹的加工程序编写成相应的子程序。

The machining parameter optimization system of NC code is designed in the process of compiling NC code. Illogical parameter is presented by result that data in technical parameter base is compared with parameter of NC program, which makes trained people understand machining parameters deeply.

在NC代码编译过程中，设计了NC程序的工艺参数优化系统，利用工艺参数库中的数据与NC程序中工艺参数进行比较，对NC程序中不合理的工艺参数提出优化建议。

A related parameter can be given in the main program, and then call the subprogram like a fixed cycle to finish the trapezoid thread's machining program.

这样就可以像固定循环一样，在主程序中给定相应的参数，然后调用子程序，就可完成相应的梯形螺纹加工程序的编写。

This paper introduces the structure and working principle of the small-sized dehumidifying device with thermoelectric refrigeration, points out the mathematics model of its system design and the optimized calculation program. At last, it gets the structural parameter that reaches the best refrigeration effects.

本文介绍了小型热电制冷除湿机结构及工作原理。提出了小型热电制冷除湿机系统设计的数学模型及优化计算程序，得出达到最佳制冷系数的结构参数。

The temperature control process and program controlled curve for high temperature reacting furnace of coke were described in the paper, the methods of realizing the control structure, main loop of program controlled curve and of realizing multiple PI parameter control were given.

介绍了焦炭高温反应炉的温控工艺及程控曲线，给出了程控曲线的控制结构、主回路以及实现多套PI参数控制的方法。

The effect of voltage fluctuation on control accuracy of the PLC-based open-loop electric heating system is investigated. The compensation method and program of time parameter correction are stated and the functions of the program are proven.

研究了电压波动对PLC开环电加热系统控制精度的影响，提出时间参数校正的补偿方法和程序，并通机验证了程序的功能。

Until the operation is completed, a parameter is effectively treated as constant value by the program.

直到操作完成时为止，一个参数都会被该程序当作一个常量业有效地处理。

Shredding method selection through program parameter.

切碎方法的选择,通过程序参数.

Program temperature rise is used for calculating dynamic parameter in thermal conversion process of interphase, and a brief analysis is made for calculated result.

用程序升温对中间相热转化过程进行动力学参数计算，并对计算结果作了简要分析。